The State has developed standard formats for metes and bounds descriptions, copies of which the Engineer’s Surveyor shall request and secure for all purposes of this Contract. In Minnesota, if the platted description is used prior to the recording of the plat, documents containing the platted descriptions would be invalid.Įxample: Lot 1, Block 1, Minneapolis Addition, Hennepin County, Minnesota.Metes and Bounds Description. A metes and bounds description must be prepared for each parcel of land to be acquired. Most often a subdivision is divided into one or more “blocks.” The blocks are then further divided into one or more “lots.” The legal description from an unrecorded plat cannot be used until that plat is recorded. However, once the plat is recorded, the smaller parcels are identified by letters or numerals instead of using the metes and bounds descriptions. Smaller parcels within the platted subdivision are mapped out with courses and distances. The plat most often uses metes and bounds descriptions to identify the perimeter of the platted land. This survey is called a plat and creates the subdivision name (e.g. Lot and BlockĪ lot and block legal description is created by filing a subdivision survey in the land records. Government Survey System.Įxample: Beginning at the Northeast corner of the Southeast Quarter of the Southwest Quarter of Section 34, Township 23, Range 16, Hennepin County, Minnesota thence East along the North line of said Southwest Quarter a distance of 125.5 feet. A metes and bounds description is commonly used in relation to the U.S. Metes and BoundsĪ metes and bounds legal description is usually one that was created by a surveyor that finds a starting point and proceeds with directions, angles and distances. Sections are further divided into quarters and so on.Įxample: The Northeast Quarter of Section 2, Township 23, Range 16, Hennepin County, Minnesota. Townships are then divided into 36 sections of one square mile each. Based upon these reference points, the land is further divided into townships of 36 square miles. Each part of the United States was assigned a specific meridian and parallel as a reference point. This system of land surveying is based on the north-south lines of longitude, which are called meridians, and the east-west lines of latitude, which are called parallels. The government or rectangular survey system was adopted by the United States in 1785. there are not two parcels described as Lot 1, Block 1, Minneapolis Addition). the lines describing the start and end of the legal description must meet) and it cannot be confused with another legal description (e.g.
In order to be valid, a legal description must close (e.g. A legal description can take different forms including reference to a government survey, metes and bounds, or a lot and block of a subdivision. The basic test as to whether a legal description is good is whether a surveyor can properly locate and identify the parcel based upon its description. A legal description is a formal description of real property that identifies the boundaries of an entire parcel.
0 kommentar(er)
